DuPont™ GroundGrid® Stabilization Grid
Once anchored, pull the grid out to a maximum length of 8m. At this point the width should be 1.25m.
Make sure that all cells maintain a uniform shape. Then anchor the Grid with more poles at the extended edge.
DuPont™ GroundGrid® stabilization grid is easily cut with scissors or a sharp knife. This means you can cut around trees or obstacles or fit it to an irregular shaped area.
Grids can be laid side by side for larger areas. You will need enough poles for anchoring (4 or 6 per grid). Overlap the open edge of each grid.
It is important to remember that you cannot walk on the grids until filled. If you are covering a large area and using a barrow to fill the grids, make sure you have access to work when filling. One method is to fill each grid as you lay it — leaving the cells nearest the overlap empty until the second grid has been laid.
If you are using a machine such as a backhoe, then you are only limited by the “stretch” of the machine’s arm.
STEP 2: Fixing to the ground
There is no need to permanently fix DuPont™ GroundGrid® stabilization grid if the soil is level — the infill and surcharge will keep the grid in position. If working on a small slope however it is good practice to permanently fix the grids with pins to the ground at regular intervals.
It is important that the grid always be in contact with the ground when filling to prevent the grid lifting. It will also prevent the infill material from flowing under the cells. Lay a length of pole or wood over the grid whilst filling and remove as you work
STEP 3: Infill
Fill each end of the grid with a handful of aggregate to hold it in place. The grid has to be in constant contact with the ground when putting aggregate into the cells. Use a timber board on top of the grid to ensure contact is made.
Use the correct size infill material for the cell size. Limit the drop height to no more than 1 meter. Whether using a wheelbarrow or machine, please take your time to make sure the infill material does not “lift” the cells. Spread the infill material evenly over the surface and ensure that each cell is fully filled using a shovel or rake.
Only crushed, angular gravel must be used to fill the cells. Pea shingle or cobble type products may only be used as a decorative surcharge on top of the grid.
STEP 4: Finishing
A surcharge of material is required on top of the grid especially in trafficked areas like car parks.
If the surcharge is a different material than the cell infill, then make sure you have filled the cells to capacity and have allowed for settlement. You may wish to use a hand roller or a compactor/vibrator to achieve final compression of the infill material.
Being manufactured from a geotextile material, the edges of GroundGrid® stabilization grid are very thin and, as such, not very visible. However, it is always advisable to maintain the recommended surcharge on top of the area to protect the edges from car wheels.
Create a strong and stable surface for your landscape or constrution site with DuPont™ GroundGrid®.