DuPont™ Granite & Marble Countertop Cleaner

Directions:

1. Spray directly on soiled area.
2. Wipe clean with a dry towel, lint-free cloth or sponge. No need to rinse.
3. Repeat for heavily soiled areas using a non-abrasive scrubbing pad and wipe clean with a dry towel.

Always read and follow all label instructions and precautions for use.

DuPont™ Granite & Marble Cleaner + Protector

Directions: Spray

1. Spray directly on soiled area.
2. Wipe clean with a dry towel, lint-free cloth or sponge. No need to rinse.
3. Repeat for heavily soiled areas

Directions: Wipes

1. Wipe directly on soiled area.
2. If necessary, wipe clean with a dry towel, lint-free cloth or sponge. No need to rinse.
3. Repeat for heavily soiled areas
   4. When finished, close lid flap to prevent wipes from drying.

Always read and follow all label instructions and precautions for use.

DuPont ™ Granite & Marble Countertop Polish

Directions:
Always test in a small inconspicuous area to determine that the desired results will be achieved. Make sure surface is clean, dry and free of oils, waxes and coatings.

1. Spray a light coat over the entire surface.
2. Spread the polish evenly with a clean, dry, white terry cloth towel.
3. Buff off polish with a clean, dry cloth towel.
4. Continue buffing until a high shine appears.

Always read and follow all label instructions and precautions for use.

DuPont™ Granite & Marble Sealer

Directions:
Always test in a small inconspicuous area and allow 24-hour cure time to determine ease of application and desired results. Allow new grout installations to cure for at least 72 hours before applying sealer. Make sure surface is clean, dry and free of oils, waxes and coatings. Ensure that the area is well-ventilated during application and until the surface is dry to the touch. Keep children and pets out of the area until foot traffic resumes.  Ensure the surface temperature of the stone is between 50-80°F before sealing.

1. Mask off and protect any baseboards or adjacent areas to avoid over-spray onto surfaces not intended to be treated.
2. Sealer may be applied to damp surfaces one-hour after standing water has been removed.
3. Liberally apply an even coat by spraying.
4. Allow sealer to penetrate the surface for 15-30 minutes. During this time, distribute excess over entire area to ensure even penetration. Remove excess sealer by thoroughly wiping entire surface with clean, dry towels.
5. A second coat may be needed for porous, absorbent surfaces and should be applied 30-40 minutes after initial application as directed in steps 3-4.
6. Wait a minimum of 15 minutes after final application and then wipe entire surface with a clean dry towel to remove any excess sealer. If sealer was not completely wiped off and a residue appears, reapply a thin coat of Sealer.  Allow sealer to sit on the surface for 2-3 minutes, agitate with a white nylon pad and dry thoroughly with clean, dry towels.
7. A full cure is achieved after 24-72 hours; foot traffic may begin in 6-8 hours. Cover with red rosin paper if foot traffic must resume before the recommended time period has passed.
8. Clean equipment with water.

Always read and follow all label instructions and precautions for use.